How to perform an operating check on the power brake booster on Toyota Matrix?

Start by depressing the brake pedal multiple times to perform an operating check on the power brake booster, making sure that there is no change in the pedal reserve distance with the engine off. Then, depress the pedal and start the engine and check if the pedal goes down slightly indicating normal operation. To check air tightness of booster, start engine and stop it after one or two minutes. After that try slowly depressing the brake pedal several times and notice whether there is less depression each time to show airtight seal. Besides, turn on the engine and press down on the brake pedal before turning off the ignition. If you hold this position for 30 seconds but there is no notable change in the pedal reserve travel indicator, then your booster is airtight. When removing them, however, power brake booster units should not be taken apart; instead they are to be replaced with a new or rebuilt one as their complexity makes them crucial to braking performance. Start by taking out the brake master cylinder and air cleaner housing. Next, disconnect a vacuum hose of a booster in an engine compartment. In any case where vehicle has cruise control system remove its actuator along with bracket. Avoid breaking any brake pipe about this booster when removing it carefully. Locate clevis attaching pushrod of booster into brake pedal then remove retaining clip from clevis pin and get out pin finally at last. Last but not least remove four nuts which support washer securing bulbous nose bonnet over firewall and slide it freely through studs until holes are not blocked by such devices anymore. Then follow removal procedures in reverse ensuring that locknut as well as mounting nuts for clevis are tightened according to specified torque values for installation purposes of course. Before fitting new power brake booster unit find out if rod clearance may cause dragging or excessive travel of brakes; take care about it using required sizes for adjustment so far as needed right now just as follows then! Finally, adjust braking height and pedal free play plus bleed this system after the completion of lastly installing brake hoses, lines, as well as master cylinder.

Genuine Toyota Matrix Brake Booster

Brake Power Booster

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

9 Brake Boosters found

View related parts
Toyota Matrix Booster Assembly, Brake
Part Number: 44610-02471
$600.02 MSRP: $883.23
You Save: $283.21 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Booster Assy, Brake; Brake Booster, Power Booster
- Manufacturer Note: VSC-WITH(W/CUT OFF SW)
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2009-2014 Toyota Matrix | 4 Cyl 2.4L | 2AZFE; 2AZFE; AZE141L-DHANKA, AZE141L-DHANKK, AZE141L-DHMNKA, AZE141L-DHMNKK, AZE144L-DHPNKA, AZE144L-DHPNKK, AZE146L-DHASKA, AZE146L-DHASKK, AZE146L-DHMSKA, AZE146L-DHMSKK
View related parts
Toyota Matrix Booster Assembly, Brake
Part Number: 44610-02460
$675.18 MSRP: $993.85
You Save: $318.67 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Booster Assy, Brake
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2009 Toyota Matrix | 4 Cyl 2.4L | 2AZFE; 2AZFE; AZE141L-DHANKA, AZE141L-DHANKK, AZE141L-DHMNKA, AZE141L-DHMNKK, AZE144L-DHPNKA, AZE144L-DHPNKK
View related parts
Toyota Matrix Booster Assembly, Brake
Part Number: 44610-02470
$675.18 MSRP: $993.85
You Save: $318.67 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Booster Assy, Brake
- Manufacturer Note: VSC-WITH(W/CUT OFF SW)
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2009 Toyota Matrix | 4 Cyl 2.4L | 2AZFE; 2AZFE; AZE141L-DHANKA, AZE141L-DHANKK, AZE141L-DHMNKA, AZE141L-DHMNKK, AZE144L-DHPNKA, AZE144L-DHPNKK, AZE146L-DHASKA, AZE146L-DHASKK, AZE146L-DHMSKA, AZE146L-DHMSKK
View related parts
Toyota Matrix Booster Assembly, Brake
Part Number: 44610-02440
$675.34 MSRP: $994.11
You Save: $318.77 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Booster Assy, Brake; Power Booster
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2009 Toyota Matrix | 4 Cyl 1.8L | 2ZRFE; 2ZRFE; ZRE142L-DHMDKA, ZRE142L-DHMDKK, ZRE142L-DHPDKA, ZRE142L-DHPDKK
View related parts
Toyota Matrix Booster Assembly, Brake
Part Number: 44610-02441
$586.06 MSRP: $862.69
You Save: $276.63 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Booster Assy, Brake; Brake Booster, Power Booster
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2009-2014 Toyota Matrix | 4 Cyl 1.8L | 2ZRFE; 2ZRFE; ZRE142L-DHMDKA, ZRE142L-DHMDKK, ZRE142L-DHPDKA, ZRE142L-DHPDKK
View related parts
Toyota Matrix Booster Assembly, Brake
Part Number: 44610-02451
$588.26 MSRP: $865.91
You Save: $277.65 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Booster Assy, Brake; Brake Booster, Power Booster
- Manufacturer Note: MEXICO SPEC
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2009-2011 Toyota Matrix | 4 Cyl 1.8L | 2ZRFE; 2ZRFE; ZRE142L-DHMDKA, ZRE142L-DHMDKK, ZRE142L-DHPDKA, ZRE142L-DHPDKK
View related parts
Toyota Matrix Booster Assembly, Brake
Part Number: 44610-02450
$675.18 MSRP: $993.85
You Save: $318.67 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Booster Assy, Brake; Power Booster
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2009 Toyota Matrix | 4 Cyl 1.8L | 2ZRFE; 2ZRFE; ZRE142L-DHMDKA, ZRE142L-DHMDKK, ZRE142L-DHPDKA, ZRE142L-DHPDKK
View related parts
Toyota Matrix Booster Assembly, Brake
Part Number: 44610-02210
$625.57 MSRP: $920.84
You Save: $295.27 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Booster Assy, Brake; Brake Booster, Power Booster
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2003-2008 Toyota Matrix | CE, LE, S, STD, XR, XRS | 4 Cyl 1.8L | 1ZZFE, 2ZZGE; 1ZZFE, 2ZZGE; ZZE130L-DEMDKA, ZZE130L-DEMDKK, ZZE130L-DEMNKA, ZZE130L-DEMNKK, ZZE130L-DEMSKA, ZZE130L-DEMSKK, ZZE130L-DEPDKA, ZZE130L-DEPDKK, ZZE130L-DEPNKA, ZZE130L-DEPNKK, ZZE130L-DEPSKA, ZZE130L-DEPSKK, ZZE131L-DEFSFA, ZZE131L-DEFSFK, ZZE132L-DHMDKA, ZZE132L-DHMDKK, ZZE132L-DHMNKA, ZZE132L-DHMNKK, ZZE132L-DHPDKA, ZZE132L-DHPDKK, ZZE132L-DHPNKA, ZZE132L-DHPNKK, ZZE133L-DHFSFA, ZZE133L-DHFSFK, ZZE133L-DHPSFA, ZZE133L-DHPSFK, ZZE134L-DHPDKA, ZZE134L-DHPDKK, ZZE134L-DHPNKA, ZZE134L-DHPNKK
View related parts
Toyota Matrix Booster Assembly, Brake
Part Number: 44610-02461
$677.51 MSRP: $997.30
You Save: $319.79 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Booster Assy, Brake; Brake Booster, Power Booster
- Manufacturer Note: MEXICO SPEC
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2009-2011 Toyota Matrix | 4 Cyl 2.4L | 2AZFE; 2AZFE; AZE141L-DHANKA, AZE141L-DHANKK, AZE141L-DHMNKA, AZE141L-DHMNKK, AZE144L-DHPNKA, AZE144L-DHPNKK

Toyota Matrix Brake Booster

If you are in demand for superior quality and affordable OEM Toyota Matrix Brake Booster, then shop with us! We own a wide range of the reduced-priced genuine Toyota Matrix Brake Booster. You can purchase in confidence as all parts come with a manufacturer's warranty. Any issues with our products? No need to worry as we have a hassle-free return policy to guide you every step of the way.

Toyota Matrix Brake Booster Parts Questions & Experts Answers

Booster Assembly, Brake
44610-02210
Q: How to perform an operating check on the power brake booster on Toyota Matrix?
A: Start by depressing the brake pedal multiple times to perform an operating check on the power brake booster, making sure that there is no change in the pedal reserve distance with the engine off. Then, depress the pedal and start the engine and check if the pedal goes down slightly indicating normal operation. To check air tightness of booster, start engine and stop it after one or two minutes. After that try slowly depressing the brake pedal several times and notice whether there is less depression each time to show airtight seal. Besides, turn on the engine and press down on the brake pedal before turning off the ignition. If you hold this position for 30 seconds but there is no notable change in the pedal reserve travel indicator, then your booster is airtight. When removing them, however, power brake booster units should not be taken apart; instead they are to be replaced with a new or rebuilt one as their complexity makes them crucial to braking performance. Start by taking out the Brake Master Cylinder and air cleaner housing. Next, disconnect a vacuum hose of a booster in an engine compartment. In any case where vehicle has cruise control system remove its actuator along with bracket. Avoid breaking any brake pipe about this booster when removing it carefully. Locate clevis attaching pushrod of booster into brake pedal then remove retaining clip from clevis pin and get out pin finally at last. Last but not least remove four nuts which support washer securing bulbous nose bonnet over firewall and slide it freely through studs until holes are not blocked by such devices anymore. Then follow removal procedures in reverse ensuring that locknut as well as mounting nuts for clevis are tightened according to specified torque values for installation purposes of course. Before fitting new power brake booster unit find out if rod clearance may cause dragging or excessive travel of brakes; take care about it using required sizes for adjustment so far as needed right now just as follows then! Finally, adjust braking height and pedal free play plus bleed this system after the completion of lastly installing brake hoses, lines, as well as master cylinder.

Related Toyota Matrix Parts

Browse by Year

2014 Brake Booster 2013 Brake Booster 2012 Brake Booster 2011 Brake Booster 2010 Brake Booster 2009 Brake Booster 2008 Brake Booster 2007 Brake Booster 2006 Brake Booster 2005 Brake Booster 2004 Brake Booster 2003 Brake Booster