Scion 13405-28020 FLYWHEEL Sub-Assembly

You can Select Your Vehicle to check if 13405-28020 fits your vehicle.

Start by removing the leaking front pump seal or O-ring, then take off the pressure plate and clutch disc. Check or replace clutch components as needed. Mark the flywheel, drive plate, and crankshaft for reinstallation. Remove the bolts securing the flywheel or drive plate to the crankshaft. Remove the flywheel or drive plate, supporting it while removing the last bolt. Align the marks made during removal, apply thread-locking compound to the bolts, and secure them in a crisscross pattern. Installation is the reverse of the removal.

First of all, detach the battery cable, and remove the transaxle and pressure plate. Mark the crankshaft flange and flywheel for alignment. Clean and inspect the flywheel before repositioning it on the crankshaft, and aligning the marks. Install the bolts in a crossing pattern and reinstall the transaxle.

To remove the flywheel/driveplate, first raise the vehicle and support it on jackstands. Remove the transaxle and replace the front pump seal/o-ring if necessary. For manual transaxle equipped vehicles, remove the pressure plate and clutch disc, and check/replace the clutch components and pilot bearing. Make alignment marks on the flywheel/driveplate and crankshaft. Remove the bolts securing the flywheel/driveplate to the crankshaft, using a screwdriver to jam the flywheel if needed. Support the flywheel while removing the last bolt and keep the spacers with the driveplate for automatic transaxle equipped vehicles. To install the flywheel/driveplate, clean it and inspect for any damage. Clean and inspect the mating surfaces of the flywheel/driveplate and crankshaft. Position the flywheel/driveplate against the crankshaft, aligning the marks made during removal. Apply thread locking compound to the bolt threads before tightening them in a criss-cross pattern. The remaining installation steps are the reverse of the removal procedure.

The first spacer is placed between the crankshaft flange and the driveplate.