Scion 90982-09025 Fuse, Mini

You can Select Your Vehicle to check if 90982-09025 fits your vehicle.

First of all, vehicle circuits are protected by fuses, circuit breakers, and fusible links. The main fuse panel is in the engine compartment, and another is inside the passenger compartment. If an electrical component fails, check the fuse first. Replace blown fuses with the correct type. If a replacement fuse fails, correct the problem before replacing it again. Some circuits use fusible links, which melt if the circuit carries too much current. Replace blown links with the same specification, and troubleshoot the circuit if the replacement link blows.

After disconnecting the cable from the negative battery terminal, simply remove the fusible link and replace it with a unit of the same amperage.

Each fuse is designed to protect a specific circuit.

Be sure to replace blown fuses with the correct type. Only fuses of the proper rating should be used, as replacing a fuse with one of a higher or lower value than specified is not recommended.

The electrical circuits of these vehicles are protected by a combination of fuses, circuit breakers, and fusible links.

Be sure to replace blown fuses with the correct type. Fuses of the same physical size but different ratings may be interchangeable, but only fuses of the proper rating should be used. Replacing a fuse with one of a higher or lower value than specified is not recommended, as each electrical circuit needs a specific amount of protection. The amperage value of each fuse is molded into the top of the fuse body.

Some circuits are protected by fusible links, which are used in circuits that are not ordinarily fused, such as the ignition circuit.

If an electrical component fails, always check the fuse first. The best way to check fuses is with a test light. Check for power at the exposed terminal tips of each fuse. If power is present on one side of the fuse but not the other, the fuse is blown. A blown fuse can also be identified visually; when a fuse blows, the element between the terminals burns.

If the relay is not being energized, then either the relay is not receiving a main supply or a switching voltage, or the relay itself is faulty. Testing is done by substituting a known good unit, but be careful as some relays may look similar but perform different functions.