Scion 87810-AA011 Inner Rear View Mirror Assembly

You can Select Your Vehicle to check if 87810-AA011 fits your vehicle.

To remove manually operated outside mirrors, start by removing the control handle and detaching the mirror cover using a small screwdriver. Then, remove the three retaining nuts and detach the mirror. For power mirrors, unplug the electrical connector before removing it. To remove the interior rearview mirror, disconnect the electrical connector if it's lighted, and use a Torx screwdriver to remove the bolt in the mirror-mounting pad. Slide the mirror off the pad and reinstall in reverse order. If the mirror pad comes off the windshield glass, use an inexpensive kit to reinstall it and allow the proper interval for bonding before attaching the car mirror.

Check the fuse.

On vehicles equipped with power side view mirrors, unplug the electrical connector.

Pry off the mirror hole cover from the inside of the door (Carefully pry off the mirror cover). Note: The door panel must be removed to disconnect the mirror wiring.

If the motors can be heard but the mirror glass doesn't move, there's a problem with the drive mechanism inside the mirror.

Remove the mirror and test it off the vehicle with jumper wires. Replace the mirror if it fails this test.

To remove or install the inside mirror, remove or install the screw at the base on the windshield.

Check the circuit between the mirror and control switch for opens and shorts.

Disconnect the wiring from the mirror if so equipped. Remove the screw at the base of the mirror, then slide the mirror upward to remove it. Installation is the reverse of removal.

If the mirror still doesn't work, the wires at the mirror should be checked for voltage. If there's no voltage in each switch position, the circuit between the mirror and control switch should be checked for opens and shorts.