Toyota 48510-09898 Shock Absorber Assembly Front Right

You can Select Your Vehicle to check if 48510-09898 fits your vehicle.

If your struts or coil springs show wear, consider all options before starting work. Strut/shock assemblies must be replaced if faulty. Check cost and availability of parts before disassembly. Remove the strut and spring assembly and mount it in a vise. Use a spring compressor to relieve pressure from the upper spring seat. Loosen the damper shaft nut and remove the nut and suspension support. Inspect the bearing and rubber portion of the suspension support, replacing if needed. Remove the upper spring seat and insulator. Lift the compressed spring from the assembly and remove the rubber bumper. Inspect the lower insulator for wear and replace if necessary. To reassemble, position the lower insulator, extend the damper rod and install the rubber bumper. Place the coil spring onto the lower insulator. Install the upper insulator and spring seat. Align the "OUT" mark of the spring upper seat with the mark of the upper insulator. Install the dust seal and suspension support onto the damper shaft. Install the nut and tighten it. Remove the spring compressor tool. Install the strut/spring assembly onto the vehicle.

For models equipped with electronic modulated suspension, you should remove the clip and clamp and disconnect the shock absorber wiring harness. Also, it mentions loosening but not removing the damper shaft nut.

Check the strut body for leaking fluid, dents, cracks, and other obvious damage. Check the coil spring for chips or cracks in the spring coating. Inspect the spring seat for cuts, hardness, and general deterioration.