Toyota 48530-59206 Shock Absorber Assembly Rear Right

You can Select Your Vehicle to check if 48530-59206 fits your vehicle.

To remove the shock absorber, start by prising off the upper trim cover and the rubber cover in the boot to access the two top nuts. Use a spanner to hold the lower nut while loosening and removing the top nut. If necessary, hold the piston rod flats with a small spanner to loosen the lower nut, leaving it fitted by a few threads until the lower mounting is removed. Next, slacken the rear wheel nuts, chock the front wheels, select 1st gear, jack up the rear of the car, and support it securely on axle stands before removing the rear roadwheel. Support the trailing arm section of the beam axle with a trolley jack, unscrew the shock absorber lower mounting nut, and slide the shock absorber off its mounting after removing the nut and washer. Lower the trailing arm, support the shock absorber, remove the upper mounting nut, and take the unit out from under the wheel arch, recovering the top washer and rubber bush from inside the boot. For refitting, ensure the shock absorber is fully reassembled and that the upper mountings are in place. Fit the lower mounting nut first and tighten it by hand. Raise the trailing arm, fit the top mounting through the hole under the wheel arch, and secure it with the upper mounting and washer, tightening the first nut to show 15 to 18 mm of the piston rod above its top surface. Attach the second nut to the first, hold the first in position, and tighten the second to the specified torque. Refit the rubber cover and plastic trim, then reattach the wheel, lower the car, and tighten the wheel nuts to the specified torque. Finally, bounce the rear of the car a couple of times to settle the suspension and tighten the shock absorber lower mounting nut to the specified torque.

Slide the spring over the strut and position it so that the lower end of the spring is resting against the stop on the lower seat.