Toyota 48068-59095 Front Suspension Control Arm Sub-Assembly Lower Right

You can Select Your Vehicle to check if 48068-59095 fits your vehicle.

To remove the lower arm, start by loosening the front wheel nuts on the relevant side, applying the handbrake, jacking up the front of the car, and securely supporting it on axle stands. Next, take off the roadwheel and the engine lower cover. Remove the spring clip and unscrew the lower arm balljoint nut, then push the end of the lower arm down to detach the balljoint from the swivel hub, using a large screwdriver if necessary while being careful not to damage the rubber seal. Hold the drop link against rotation with a spanner and remove the lower nut to disconnect it from the lower arm, ensuring to recover the washers and bushes in their fitted order. After that, remove the lower arm front pivot bolt and unscrew the rear mounting bolt to take the lower arm out from under the car. During the overhaul, check the rubber bushes and suspension lower balljoint for wear and damage, replacing the entire lower arm if any issues are found. For refitting, reverse the removal steps while ensuring all fixings are tightened to the specified torque, initially tightening the front pivot and rear mounting bolts by hand before fully tightening them once the car is lowered and the weight is on the suspension. Use a new spring clip on the lower arm balljoint nut, and if needed, tighten the balljoint nut up to 60° past its torque value to fit the spring clip. Finally, have the front wheel alignment checked upon completion.