Toyota 58812-47010-B0 Box, Console, LH

You can Select Your Vehicle to check if 58812-47010-B0 fits your vehicle.

Disconnect the cable from the negative terminal of the auxiliary 12-volt battery, ensuring to perform the initialization procedure upon reconnection. For 2001 through 2003 models, remove the three bolts and lift off the console box, with installation being the reverse of removal. For 2004 through 2009 models, pull the top of the console assembly upwards while releasing the two clips at the bottom front, disconnect the four clips around the upper section, and lift it free. Remove the four screws securing the front cup holder assembly, the console box pocket, and the carpet liner. Grasp the rear panel of the console box and pull it rearward and upward to release the six clips, then remove the four screws and the rear cup holder. Remove the two screws from the front sides of the console box and the two bolts from the inside rear, lifting the console box out and disconnecting the wiring. Installation is the reverse of removal. For 2010 and later models, on those with a power outlet, pull up and remove the rear console pocket, then use a plastic trim tool or a screwdriver wrapped with tape to pry up the upper console trim panel. Remove the carpet from the bottom of the console storage box and the screws from the bottom, noting that some models may have an additional screw at the top front of the console. Pull the console to the rear to release the claw retainers, then lift out the box, with installation being the reverse of removal.