Toyota 90981-13018 Bulb, Fog Lamp

You can Select Your Vehicle to check if 90981-13018 fits your vehicle.

To delete the turn signals and the fog lights, first you need to detach the radiator grille. For turn signal replacement, unscrew the lens retention screws, and gently pry the lens housing off the vehicle body, then twist the bushing of the bulb holder and remove it to change the bulb. Fog lights are as follows by unscrewing the retaining screws on the frame that are holding the housing to the vehicle and then pulling the housing out and unplugging the electrical connector from the back. For front side marker lights, unscrew the corresponding screws, then twist the lens and take it off; after that, insert a bulb and take it out. The rear side marker and rear turn signal lights can be replaced from the interior of the luggage compartment: the storage compartment cover should be dismantled and an inside panel should be gratuitously disconnected to expose the bulb holders. Twist the holder anti-clockwise to unlock it from the side marker assembly and then pull the bulb straight up. On the left side, localized behind the tool/jack storage compartment, that is accessible by removing the said compartment, there shall be the bulb holder. In the case of the dome light, take off the translucent plastic piece with an initiative of a screwdriver and pull the bulb out. They state that to delete an instrument panel bulb, the person has to use a screw-driver and unfasten the instrument cluster, then by rotating it anti-clockwise one has to pull the specific bulb carrier from the printed circuit board. One can open the liftgate to reach the rear combination light: there is a panel that covers the back side of the assembly, and it can be unplugged on a tab; the burnt out bulb will need to be removed and replaced. The location for the license plate light is as follows; first, strip off the covering panel to expose the bulb holder after that you rotate the bulb holder counterclockwise to provide clearance before pulling the bulb out. Removing the lights is the process of uninstalling them and, after that, check the luminosity of the acquired lights.

To gain access to the bulbs in these assemblies, simply remove the lenses by removing the lens retaining screws, pulling the lens free, and twisting the bulb counterclockwise to free it.