Toyota 33820-1A220 Cable Assy, Transmission Control

You can Select Your Vehicle to check if 33820-1A220 fits your vehicle.

When the shift lever inside the vehicle is changed from the Neutral position to another position, it changes to a new position seamlessly, and exactly to the required position, with the shift indicating the correct position. If the alignment of the indicator is off, the position of the shift cable can be adjusted by first loosening the swivel nut located on the manual shift lever at the transaxle before moving the manual lever down to the Park position and back up two notches to the Neutral position, this action should be accompanied by making sure that the shift lever found inside the vehicle is also in the Neutrual position before completing the process of fastening the After such correction, it is necessary to ensure that the functioning of the transaxle is checked in each position of the shift lever, to work in the Park and Neutral only the starter. For replacement, the negative battery cable should be disconnected, then the cable which is coming out of the tie bar shield, the large C-clip cable retainer on the bracket which is above the manual lever. Subsequently, and to gain access to the Boarding Data Sheet, it was necessary to remove the floor console, together, with portions of carpeting ahead of the floor tunnel as well. The nut screws fastening the airbag ECU to the floor should be loosened and aside because shift cable is below the ECU. The bolts which are attached on the cable housing retainer on the floor inside the vehicle need to be unfixed, likewise, the cable should be detached by prying the ends off from the shift housing and eye must be unbolted from the shifter. The cable and grommet has then to be pulled through the floor pan again and while installing it again should be noted that the same should be done in the reverse order followed during removal of the floor pan while after adjustment of the cable should also be made.

Under the vehicle, remove the two nuts securing the cable bracket to the floor, then pull the cables/grommet through the floor and out.