Toyota 77035-33130 Cable Sub-Assy, Fuel Lid Lock Control

You can Select Your Vehicle to check if 77035-33130 fits your vehicle.

To start with, remove the trunk lid trim panel in order to get rid of the trunk release switch. Then remove the trunk latch and lock assembly. To take out the trim, undo the nuts that hold it down from inside of the trunk lid and carefully pry it off. Finally, unscrew the mounting screws for the switch, detach its harness clips and remove it from its housing on the trim panel. Installation is accomplished in reverse order of removal. To access fuel door release motor you will have to remove rear floor mat, spare tire and left side interior body panel located in trunk. Open fuel door and remove nut. Lock-to-door cable can be removed by turning sleeve at end of cable counterclockwise and pulling back on sleeve. After disconnecting electrical connector, removing mounting nut, remove motor. Remove bolts attaching fuel door to vehicle body. Similarly installation is opposite to removal. Take off floor mat and left-side panel inside trunk for access to cable end when removing fuel door cable. Push tabs of fuel door latch cable end inwards then pull it out from fuel door housing. In addition untwist this way thus removing cable end retainer from bracket.Put up rear seat bottom as well as lower trim panels of center door pillar.Side carpeting should be peeled back so that release cable can be accessed; after disengaging all clips that hold wire on body.Remove bolt holding handle assembly to floor.Then turn housing over and take off cable housings from clips as well as eyes from levers.Tie thin wire at end of cable.Working within trunk compartment pull it rearwards until wire is visible.Attached wire again in front of new one then fish it back through body such that lever can reach.The remaining installation process follows a complete reversal of initial steps.