Toyota 33822-02111 Cable Transmission Control Select

You can Select Your Vehicle to check if 33822-02111 fits your vehicle.

Where there is a change of gear selection from one Neutral position inside the vehicle to another it should be smooth and precise with the shift indicators displaying the exact position of the specific gear. If the specified indicator is untidy, then the shift cable may be adjusted by loosening the nut for shift lever on the transaxle and moving the manual shift lever down into the PARK and then into NEUTRAL position and then moving it two notch from the NEUTRAL position, at the same time ensuring that there is also NEUTRAL indication inside the vehicle by tightening the swivel nut firmly while holding the lever slightly towards the REVERSE After these adjustments, the working of the transaxle has to be tested in every shift lever position; the engine has to start only when the shift lever is in the Park and Neutral positions. For replacement, the cable should be connected to the negative terminal of the battery and the cable would be disconnected from the manual lever followed by the removal of the large 'C' clip cable retainer. Thus, the mount on the cable accessible at the floor entails the removal of the floor console, carpeting, floor ducts, floor panel brace, and the exhaust pipe. The component to be checked in the black dome connected to the steering wheel is the airbag ECU, which is removed after loosening its securing bolts, and before this is accomplished, other bolts that are a part of the cable-housing retainer should also be removed. The cable ends can then be pulled off the shift housing and the eye of the cable can then be removed from the shifter. The cable and grommet need to be pulled through the floor pan, the process of installation is the process of reversing at the same time, if the cable end is serrated, before connecting to the arm, it must be placed on the floor-shift assembly; After a period of installation, the adjustment must be made.

Remove the center floor console.

Pry off the cable ends from the shift housing and disconnect the cable eye from the shifter by twisting the flange to release its clips, then removing the clips and prying the cable eye from the shifter arm.

Pull back the carpeting and remove the fasteners securing the airbag ECU to the floor and set the ECU aside.