Toyota 90919-A2007 Ignition Coil Assembly

You can Select Your Vehicle to check if 90919-A2007 fits your vehicle.

To disconnect the cable from the negative battery terminal, start by removing the engine cover on 2009 and earlier models by taking off the mounting fasteners and lifting it off. On 2010 and later models, lift the engine cover up from the rear and then the front, removing it from the mounting pins. For V6 engines, pry the engine cover up from the rear and remove it from the mounting pins. To access the rear ignition coils, remove the upper intake manifold. Each ignition coil/igniter assembly is secured by one bolt, so unscrew the bolt, disconnect the electrical connector, and pull the coil/igniter assembly straight up using a twisting motion. The individual ignition coil boot directly mounts over each spark plug. Installation is the reverse of removal.

Each ignition coil/igniter assembly is secured by one bolt, so unscrew the bolt, disconnect the electrical connector, and pull the coil/igniter assembly straight up using a twisting motion.

If you need to remove the ignition coil on the rear cylinder head of V6 models, you'll also need to remove the upper intake manifold.

Please provide the VIN so we can verify the firing order and identify which ignition coil is which

They are manufactured in China and Taiwan

This part number is for the set of 6 coils

No, there are no necessary gaskets that you need to replace or add

Yes, the part number is stamped on them

Denso is the manufacturer for Toyota parts

Yes, they are 100% genuine Toyota ignition coils