Toyota 88460-06140 Condenser Assy, Cooler

You can Select Your Vehicle to check if 88460-06140 fits your vehicle.

Have the refrigerant discharged by an air conditioning technician. Remove the radiator upper mounts. On models with a separately mounted receiver/drier, remove the receiver/drier. Disconnect the inlet and outlet fittings. Remove the bolts holding the refrigerant lines to the right side of the condenser on some models, the line is clamped to the side of the condenser as well. Cap the open fittings immediately to keep moisture and dirt out of the system. Remove the mounting nuts/bolts. Remove the mounting bolt and nut at the condenser bracket on each side. Push the radiator back toward the engine, then push the condenser rearward until it is free of the radiator support and can be pulled up and out of the vehicle. Install the condenser, brackets, and bolts, making sure the rubber cushions fit on the mounting points properly. Reconnect the refrigerant lines, using new O-rings where needed. Reinstall the remaining parts in the reverse order of removal.