Toyota 55900-0C080 Control Assembly, Air Co

You can Select Your Vehicle to check if 55900-0C080 fits your vehicle.

Some models of the Sequoia are equipped with rear heating and air conditioning, with the rear AIC unit housing the heater core and evaporator. To remove the front mounted A/C Switch, disconnect the negative cable from the battery and remove the lower and center instrument panel trim and center console. Carefully pry out the integration and A/C Switch until the electrical connectors can be disconnected, then remove the A/C Switch. For 2014 models, remove the A/C Switch-to-panel mounting screws and separate the A/C Switch from the trim panel. Installation is the reverse of removal. To remove the rear-mounted A/C Switch, release the clips on each side of the center console rear panel and pull it off the floor console. Disconnect the electrical connectors and harness clamps, then pull the A/C Switch out slightly and disconnect the connectors. Remove the A/C Switch mounting screws, release the clips, and remove the A/C Switch from the console end panel. Installation is the reverse of removal. Finally, run the engine and check for proper functioning of the heater and air conditioning, if equipped.