Toyota 31420-33030 Cylinder Assy, Clutch Master

You can Select Your Vehicle to check if 31420-33030 fits your vehicle.

To remove the components, first and foremost unclip the negative terminal wire from the battery followed by the separation of the power brake booster. In the engine compartment, remove the clutch reservoir tube clamp from the clutch master cylinder with pliers keeping in mind that some fluid will be lost; do not allow the brake fluid to touch the paint. Subsequently, take off the knee bolster and then detach the pushrod from the upper portion of the clutch pedal - disengage the pin together with the clip. Reach under the dash and unbolt the clutch hydraulic line using a flare-nut wrench since it is not advisable to round off the center and be sure to put a can and rags to contain any spillage of the liquid. The nuts on the master cylinder mounting has to be deloused and then the master cylinder together with gasket has to be taken out with extra precaution not to spill the fluid. During installation of the master cylinder, align the master cylinder to the pedal assembly and firewall and tighten the mounting nuts just enough with your fingers. Attach the hydraulic line to the master cylinder while making sure you do not cross thread the fitting. After that, tighten the mounting nuts to the desired torque and fasten the hydraulic line fitting. Replace the pushrod to the clutch pedal, fit the clutch reservoir tube in position and refill the clutch master cylinder reservoir with brake fluid that meets DOT 3 and then bleed the clutch system. Lastly, in order to carry out the completion of the installation process, follow the steps that were followed during the removal process in exactly the opposite manner.