Toyota 88474-08010 Dryer, Cooler

You can Select Your Vehicle to check if 88474-08010 fits your vehicle.

Firstly, ensure the refrigerant is discharged by an air conditioning technician. Then, disconnect the cable from the negative battery terminal. Proceed to remove the condenser and using an Allen wrench, detach the end plug and remove the A/C Accumulator from the A/C Condenser. To secure the end plug, ensure it's tightened properly. Finally, have the system evacuated, charged, and leak tested by the same shop that discharged it. If the receiver was replaced, request them to add the proper amount of refrigeration oil to the compressor. Only use A/C Compressor oil that is compatible with R-134a refrigerant.

Using an Allen wrench, detach the end plug. After the system has been discharged, remove the Allen plug and pull the driver from the tube on the condenser, then remove the drier from the condenser with a pair of needle-nose pliers. Note: If the end plug is not accessible with the air conditioning condenser installed, the condenser may have to be removed.

The bumper cover should be removed and a hex bit or Allen wrench should be used to unscrew the end plug and remove the receiver/drier from the condenser.

The first step is to ensure the refrigerant is discharged by an air conditioning technician.