Toyota 81980-36060 Flasher Assy, Turn Signal

You can Select Your Vehicle to check if 81980-36060 fits your vehicle.

The turn signal & hazardous flasher is enclosed in a cylindrical shaped box at the relay area near the steering column. Normally, the Flasher unit will produce a clicking sound when it is functioning or working as it should. If the turn signals are on one side, and the flasher does not click, then it is most probably that the turn signal bulb is bad. If both the turn signals do not blink then the causes could be a bad or blower fuse, the flasher unit is bad, bad switch, or loose or open connection. It is also possible to get to the turn signal fuse and see that it has blown, at the same time, it is recommended to check for the short in the wiring before replacing the turned off fuse. To replace the flasher, all one has to do is remove the flasher from the relay panel and install a new flasher provided that it is of the same make and model as the flasher that was removed as one can easily check this by comparing the two before fixing. The process of installation is just the opposite to the process of removal described above.

Connect a fused jumper wire between one of the control circuit terminals and the positive battery terminal, and another jumper wire between the other control circuit terminal and ground. The relay should click when the connections are made. If it doesn't click, try swapping the jumper wires on the control circuit terminals.