Toyota 53301-0C030 Hood Sub-Assembly

You can Select Your Vehicle to check if 53301-0C030 fits your vehicle.

The hood is somewhat awkward to remove and install, so at least two people should perform this procedure. Begin by opening the hood and placing rags or covers over the windshield and fenders for protection. Disconnect the windshield washer fluid lines and mark the relationship of the hood to the hinges before removing the hinge bolts. Use a screwdriver to detach the hood support struts by prying off the clips. With an assistant supporting one side of the hood, take turns removing the hinge-to-hood bolts and then remove the hood. For installation, reverse the removal steps. If necessary after installation, adjust the entire hood latch assembly up and down as well as side to side on the upper radiator support to ensure the hood closes securely and is flush with the fenders. Scribe a line around the hood latch mounting bolts for reference, loosen the bolts, and reposition the latch as needed. Note that factory bolts are centering types that do not allow adjustment; replace them with standard bolts, flat washers, and lock washers for proper adjustment. After making adjustments, retighten the mounting bolts. Finally, adjust the hood bumpers to ensure the hood is flush with the fenders when closed, and periodically lubricate the hood latch and hinges with white lithium-based grease to prevent sticking and wear.

Use a screwdriver to pry the clip off and detach the hood support strut.