Toyota 90947-A2018 Hose, Flexible

You can Select Your Vehicle to check if 90947-A2018 fits your vehicle.

When replacing flexible hoses, follow these steps: Loosen wheel lug nuts and raise the vehicle on jackstands. Remove the wheel for access. Unscrew the brake line fitting from the hose using a flare-nut wrench to protect the corners. Remove the U-clip from the bracket at the frame and pass the hose through. At the caliper end, remove the banjo fitting bolt and separate the hose from the caliper, replacing copper washers. Remove the U-clip from the strut bracket and feed the hose through. Connect the caliper fitting to the caliper using the banjo bolt and washers. Insert the metal support into the strut bracket, install the U-clip, and ensure the hose isn't twisted. Route the hose into the frame bracket, connect the brake line fitting, and secure it with a clip and E-ring if present. Bleed the caliper, install the wheel, lower the vehicle, and tighten the lug nuts.

When replacing metal brake lines, follow these steps: Use genuine steel brake lines obtained from a dealer or auto parts store. Prefabricated lines with flared tube ends and fittings can be used. During installation, ensure proper support and clearance for the new line, preventing contact with moving or hot components. After installation, check the master cylinder fluid level and add fluid as needed. Bleed the brake system and test the brakes before driving in traffic.

There are two copper sealing washers on either side of the fitting that should be replaced with new ones during installation.

A light and mirror will be helpful.