Toyota 43550-42020 Front Axle Bearing And Hub Assembly, Right

You can Select Your Vehicle to check if 43550-42020 fits your vehicle.

Here are the instructions on how to take off the hub and bearing, first, loosen the driveaxle/hub nut. Then, unscrew the wheel lug nuts, lift the car and firmly put it on jackstands; put some blocks in behind the car to keep the rear wheels from moving. Take off the wheel, that's it remove the brake caliper and the disc. Lose the front speed sensor, balljoint-to-lower arm bolt, and nuts to disconnect the control arm at the steering knuckle balljoint employing a large pry bar or a screwdriver. Slide the driveaxle off the hub splines after straining on the knuckle to extract the driveaxle with wire or rope. Take out the four bolts located at the back of the steering knuckle, and then pull of the hub and bearing assembly. To install the product, place the hub and bearing assembly on the knuckle, and after all the four bolts are put in place, tighten them. Next, slide the driveaxle into the hub splines Then place the brake disc and the caliper and the speed senor and then the wheel. Last of all, lower it, right tighten the lug nuts, right tighten the driveaxle/hub nut and put in a new cotter pin.

Loosen the rear driveaxle/hub nut.