Toyota 17120-0S010 Manifold, Intake

You can Select Your Vehicle to check if 17120-0S010 fits your vehicle.

1. Remove the upper intake manifold (see Steps 1 through 7). 2. Remove the fuel rail and injectors. 3. Clearly label and detach all remaining wires, hoses, and brackets attached to the lower intake manifold, coolant outlets, and rear coolant bypass casting. 4. Remove the mounting nuts and bolts, then detach the intake manifold from the cylinder heads, starting with the outer bolts and working towards the inner bolts. Make several passes to ensure even separation. If it's stuck, do not pry between the gasket mating surfaces to avoid damage.

Check the condition of the upper intake manifold gasket and replace it if necessary.

1. Remove the engine cover. 2. Remove the windshield wiper motor and linkage. 3. Remove the eight cowl panel bolts and the cowl. 4. Drain the cooling system. 5. Remove the air intake duct. 6. Remove the throttle body. 7. Clearly label and detach all wires, hoses, and brackets attached to the intake manifold. 8. Disconnect the water bypass hoses and move them out of the way. 9. Remove the fuel rail insulators from both sides of the engine. 10. Disconnect the wiring harness clamps at the rear of the intake manifold. 11. Remove the mounting nuts and bolts, then detach the intake manifold from the cylinder heads, starting with the outer bolts and working towards the inner bolts. Make several passes to ensure even separation. If it's stuck, do not pry between the gasket mating surfaces to avoid damage.

Check the condition of the upper intake manifold gasket and replace it if necessary.