Toyota 04465-42200 Front Disc Brake Pad Kit

You can Select Your Vehicle to check if 04465-42200 fits your vehicle.

First, unscrew the cap of the brake fluid container; thereafter, deflate the tire under examination, free the wheel lug nuts and jack up the car while securing it on jackstands while placing blocks beneath the wheels at the opposite corner. Move on to the removal of the wheels, which has to be done for one brake assembly at a time, and if required, use the assembled brake to keep yourself in check. Check the condition of the brake disc and or if it has been machined or replaced, then pulling the disc out comes with the pads. To make room for the new brake pads, push the piston back into the bore by applying pressure with a C-clamp so that the master cylinder does not spill its fluid; drain some if necessary. Cleaning brake before the dismantling is advised using brake cleaner, and then perform the removal procedure of the caliper by unscrewing the lower bolt at the tightening point of the sliding pin next to the lower bolt and followed by the upper bolt. Pull the caliper away from the brake pads and, to maintain the flexing in the flexible brake hose, park it to the side; then, diconnect the outer and inner brake pad with its brake pad support plates. Apply grease to the support plates and/caliper guide pins, fit the new brake pads to the caliper mounting bracket and tighten the caliper mounting bolts to the recommended torque value. Make sure the mounting bolts are tight when you recenter the caliper and after you are done with the job, engage the brake several times to have the pads touching the disc. Ensure the brake fluid level is correct and add if not, then exercising a large amount of caution properly check the brakes before getting the vehicle back into general use. For rear disc brakes, clean the brakes with brake cleaner, retract the piston into its bore with the help of a C-clamp and make sure that the fluid spilling over. While unscrewing the upper caliper bolt but retaining the pin, turn the caliper at the lower pin, and suspend it from wire to reach the brake pads. Take out the brake pads and its clips, then lubricate the contact area and fit new 'brake pads' and tighten the 'caliper mounting bolts' to the stipulated torque. After reinstalling the caliper perform firmly depressed the brake pedal, check the fluid level and ensure correct operating of the brake before normal running.