Toyota 23220-28180 Fuel Pump Assembly

You can Select Your Vehicle to check if 23220-28180 fits your vehicle.

Remove the retaining bolts on 2006 and earlier models, or remove the retaining ring on 2007 and later models using a special tool. Carefully lift the assembly, angling it to protect the fuel inlet strainer and the sending unit float.

The high-pressure tube can be disconnected by using a wrench to loosen and remove it.

If the EFI fuse and relay are fine but there is still no sound from the fuel pump, you should check the wiring back to the fuel pump.

To begin, remove the sending unit assembly from the fuel tank and drain any remaining gasoline from the pump/sending unit. Place the pump/sending unit on a clean workbench in a well-ventilated area. For 2007 and earlier models (except the 2007 RX 350), carefully pry off the end cap from the lower end of the fuel pump/sending unit assembly and remove the rubber insulator from the lower end of the fuel pump. Then, remove the fuel pump inlet strainer by disengaging the locking tabs with a pair of screwdrivers. Disconnect the fuel pressure regulator from the fuel return jet tube hose and fuel filter, and remove the fuel return jet tube assembly by pulling it out of the retainer clip. Disconnect the fuel pump electrical connector and remove the fuel pump from the fuel filter assembly. Separate the fuel filter housing from the upper part of the fuel pump assembly by disengaging the four locking tabs. Detach the fuel level sending unit from the upper part of the fuel pump assembly by disengaging the locking tangs from the lugs on the upper part of the pump.