Toyota 15100-22041 Pump Assembly, Oil

You can Select Your Vehicle to check if 15100-22041 fits your vehicle.

To remove the timing chain and crankshaft sprocket, detach the oil pump body from the engine by removing five bolts, using a screwdriver to carefully pry between the block and the pump body if needed. Clean all traces of sealant and old gasket material from the pump body and engine block with a scraper, then use lacquer thinner or acetone on the mating surfaces. Take out the oil pressure relief valve from the pump body, then remove three screws to separate the pump cover from the body and lift out the driver and driven rotors. Clean all components with solvent and inspect for wear and damage, checking the oil pressure relief valve piston sliding surface and valve spring; if either is damaged, replace them as a set. Measure the driven rotor-to-body clearance, rotor-to-cover clearance, and drive rotor tip clearance with a feeler gauge, comparing results to specifications; replace rotors as a set if any clearance is excessive, and replace the oil pump body if necessary. Check the timing chain guide oil jet for blockage. For installation, lubricate the drive and driven rotors with clean engine oil and place them in the pump body with the marks facing out. Pack the pump cavity with petroleum jelly, attach the pump cover, and tighten the screws to the specified torque. Lubricate the oil pressure relief valve piston with clean engine oil and reinstall the valve components in the pump body. Place a new oil pump gasket on the engine block, position the pump assembly against the block, and install the mounting bolts, ensuring the flats on the oil pump drive rotor align with the crankshaft. Tighten the bolts to the specified torque in three or four steps using a criss-cross pattern to avoid warping. Reinstall the remaining parts in reverse order of removal, add oil if necessary, start the engine, and check for oil pressure and leaks.

Tighten the bolts to the torque in three or four steps, following a criss-cross pattern to avoid warping the body.