Toyota 45460-19225 Rod Assy, Tie, LH

You can Select Your Vehicle to check if 45460-19225 fits your vehicle.

Half loosen the wheel lug nuts but do not remove them, then safely lift the front part of the vehicle and support it on jack stands, then finally, remove the front wheel. Next release the clamp bolt which secures the tie-rod end to the tie-rod and make an alignment mark on the thread of the tie-rod end so that it may be fitted in the same position again. Unscrew the cotter pin and then you undo the castellated nut that you will find on the tie-rod end stud. Screw off the half of the nut that is attached to the tie-rod end by operating the puller, while loosening the castellated nut several turns to prevent it to suddenly come off, then unscrew the tie-rod end from the tie-rod. Screw the tie-rod end while aligning it to reach the alignment mark on the steering rack, then tighten the clamp bolt. Involve the extension of the tie rod end stud through the arm of the steering knuckle and lock it with required torque to engage a new castellated nut and cotter pin. It is suggested that the toe-in should be adjusted using the car at a dealer service department or at an alignment shop after install of the tie-rod end.