Toyota 85214-0T050 Rubber, Wiper Blade, Left

You can Select Your Vehicle to check if 85214-0T050 fits your vehicle.

The windshield wiper and blade combination are to be checked for damage, loose parts, cracked or worn blades. Wiper blades can get a coat of dirt on them, which affects their performance, hence they must be cleaned with mild detergent solution. The motion of the wiping system can cause nuts, bolts and fasteners to become loose so that they should be inspected and tightened at the same time as the wiper blades. If the blade elements have cracks, are gone out of shape or no longer do their job properly, then these should be replaced with new ones. Lift the wiper arm assembly off of the glass surface and then flip up tab to release the windshield wiper frame assembly from wiper arm. Squeeze the end of the windshield wiper element out of its frame. Inserted into either end of a new element without slits is this frame's end. At last work the rubber along blade frame slot until cutouts catch on the wiper frame claw.

Work the rubber along the slot in the blade frame until the cutouts are locked into place by the wiper frame claw.

The refill measures 23.5 inches in length

The part number for the right side is 85214-30400

Yes, the left one would be part number 85214-0T050

85214-0T050 is the driver side, 85214-0T040 is the passenger side, and 85214-0E050 is the rear one

No, they are supposed to be the exact length but you can cut off the extra just make sure you don't over cut

This product only comes with one blade

Yes you need the toyota metal piece that holds the refill

No, these are made to fit and are not meant to be cut