Toyota 90311-38059 Seal, Oil

You can Select Your Vehicle to check if 90311-38059 fits your vehicle.

Remove the crankshaft pulley and note how the seal is installed, ensuring the new one is positioned to the same depth and orientation. Carefully pry the oil seal out of the cover using a seal puller or a large screwdriver, taking care not to damage the crankshaft. To facilitate removal, cut the lip of the seal with a utility knife, and avoid distorting the cover or scratching the crankshaft by wrapping electrician's tape around the screwdriver tip. Apply clean engine oil or multi-purpose grease to the outer edge of the new seal, then install it in the cover with the lip facing inward. Drive the seal into place using a seal driver or a large socket and hammer, ensuring it enters the bore squarely and stops at the proper depth. Check the surface on the pulley hub where the oil seal rides; if it shows grooves from prolonged contact, a press-on sleeve may be available to renew the sealing surface. This sleeve can be pressed into place with a hammer and a block of wood, commonly found at auto parts stores. Lubricate the pulley hub with clean engine oil and reinstall the crankshaft pulley, then install the retaining bolt and tighten it to the specified torque. The remainder of the installation follows the reverse order of removal.

Pry the oil seal from the rear of the engine with a screwdriver. Carefully pry out the old seal, and it may be helpful to cut the seal lip with a razor blade first to make removal easier. Be careful not to nick or scratch the crankshaft or the seal bore. Note how far the seal is recessed into the bore before removal so the new seal can be installed to the same depth. Thoroughly clean the seal bore in the block with a shop towel, removing all traces of oil and dirt.

Remove the crankshaft pulley.

Pry the oil seal from the rear of the engine with a screwdriver, being careful not to nick or scratch the crankshaft or the seal bore. Note how far it's recessed into the bore before removal so the new seal can be installed to the same depth.