Toyota 43410-06252 Shaft Assembly, Front Drive, Right

You can Select Your Vehicle to check if 43410-06252 fits your vehicle.

Place a large bolt with two large washers through the hub and tighten the nut securely.

The inner ends of the driveaxles are equipped with sliding constant velocity joints, which are capable of both angular and axial motion. Each inner joint assembly consists of either a tripod bearing and a joint tulip (housing) or a ball-and-cage type constant velocity joint, allowing the joint to slide in-and-out as the driveaxle moves up-and-down with the wheel. The joints can be disassembled and cleaned in the event of a boot failure, but if any parts are damaged, the joints must be replaced as a unit.