Toyota 37110-0C130 Propelle Shaft Assembly

You can Select Your Vehicle to check if 37110-0C130 fits your vehicle.

To properly lubricate your vehicle, you will need a grease gun, clean rags, engine oil, chassis grease, lithium base grease, spray-on graphite or silicone lubricant. Begin by raising the vehicle with a jack and placing jackstands under the frame for easier access. Look under the vehicle for grease fittings on the driveshaft universal joints and slip yokes. Wipe the area around the grease fitting clean and force a little grease out of the nozzle to remove any dirt. Squeeze the trigger on the grease gun to force grease into the component until it oozes out of the bearing cup seals. Wipe off excess grease and repeat the procedure for the remaining fittings. Lubricate the driveshaft slip yoke by pumping grease into the fitting until it comes out of the slip yoke seal. Clean and lubricate the parking brake cable, cable guides, and levers with chassis grease. Lubricate the contact points on the steering knuckle stop with lithium base grease. Smear chassis grease on the hood latch mechanism and lubricate the cable at the latch. Lubricate all hinges with engine oil and the key lock cylinders with spray-on graphite or silicone lubricant. Finally, lubricate the door weather-stripping with silicone spray to reduce chafing and wear.

Raise the rear of the driveshaft into position and check to be sure the marks are in alignment. If not, turn the rear wheels to match the pinion flange and the driveshaft.

When the vehicle is raised for service, it's a good idea to clean the driveshaft and inspect it for any obvious damage.