Toyota 86160-0WD10 Speaker Assembly, Radio

You can Select Your Vehicle to check if 86160-0WD10 fits your vehicle.

1. Use a plastic trim tool or a screwdriver wrapped with tape to carefully pry up and remove the integration control panel. 2. Pull up the rear of the lower center instrument cluster trim panel and remove it, disengaging the clips as you go. 3. Disengage the 14 claws and pry off the instrument cluster finish trim panel. 4. Remove the upper instrument panel trim piece at the right of the steering wheel and disconnect the wiring. 5. Remove the four radio mounting screws and release the four claws as you pull the radio from the instrument panel. 6. Disconnect the electrical connector from the radio when it's clear. 7. Remove the bracket from the radio if necessary. 8. Installation is the reverse of removal.