Toyota 04371-60070 Spider Kit, Universal Joint

You can Select Your Vehicle to check if 04371-60070 fits your vehicle.

To remove the Drive Shaft, start by loosening the wheel lug nuts and raising the vehicle on jack stands. Place the driveshaft on a bench with a vise. Mark the shaft and yoke for reassembly and remove the snap rings from the Universal Joint. Use a pipe or socket to press one bearing cup out of the yoke, supporting it with a smaller socket. Use pliers or a vise to remove the other bearing cup. Clean the yokes thoroughly, removing any dirt or debris and eliminating metal burrs. For installation, pack the new U-joint bearing cups with grease, following the provided lubrication instructions. Position the U-joint body in the yoke and partially install one bearing cup, ensuring the grease fitting points in the same direction as the grease filling on the opposite end. Start the U-joint body into the other cup and align it between the bearing cups. Press the bearing cups into position, being careful not to damage the dust seals. Install the snap-rings, using a hammer if necessary. Install the driveshaft, lubricate the grease fitting if present, remove the jack stands, and lower the vehicle.

The driveshaft is a tubular construction designed as a one-section type that transmits power from the transmission or transfer case to the differential.

DOESNT GIVE DIMENSION OR SIZES