Toyota 28100-0V012 Starter Assembly

You can Select Your Vehicle to check if 28100-0V012 fits your vehicle.

To remove the starter motor assembly from the engine compartment, begin by disconnecting the cable from the negative battery terminal. Then, remove the engine cover(s), air filter housing, and air inlet duct. Next, detach the electrical connectors from the starter/solenoid assembly. Unscrew the starter motor assembly and remove it. To reinstall, switch the removal steps going from the last step to the first step.

For Highlander models with a 2GR-FKS engine, disconnect the cable from the negative battery terminal and remove the battery and battery tray. For 2GR-FE models, simply remove the battery. Then, remove the air filter housing and air intake duct. For 1999 through 2003 V6 models, remove the starter motor first, then disconnect the electrical connectors. For RX350 models with a 2GR-FKS engine, disconnect the transaxle shift control cable and remove the bracket mounting bolts and bracket from the transaxle. For 2004 and later models, disconnect the electrical connectors and remove the starter mounting bolts, then remove the starter.

The circuit should be repaired and the fusible link replaced.

Installation is the reverse of removal. Make sure to tighten the starter motor mounting bolts.