Toyota 77020-0E060 Fuel Suction Tube Assembly W/Pump & Gage

You can Select Your Vehicle to check if 77020-0E060 fits your vehicle.

Inspect the O-ring inside the fitting and replace if damaged.

If the EFI fuse and relay are fine but there is still no sound from the fuel pump, you should check the wiring back to the fuel pump.

For 2007 RX 350 and all 2008 and later models, the components of the fuel pump assembly are modular and attached to the main housing. To remove the fuel level sending unit, disconnect the electrical connector and pry it from the clips. To remove the fuel pump, disconnect the electrical connector from the mounting flange, remove the spring E-clip, release the claw connectors from the sub-tank, separate the fuel suction support base, release the claw connectors and separate the fuel pump assembly, disconnect and remove the fuel pump electrical harness, and pull the fuel pump up and out from the filter assembly. Remove the O-ring and spacer from the fuel pump, and inspect the strainer for contamination.

The high-pressure tube can be disconnected by using a wrench to loosen and remove it.