Toyota 77020-0E090 Fuel Suction Tube Assembly W/Pump & Gage

You can Select Your Vehicle to check if 77020-0E090 fits your vehicle.

After removing the high-pressure fuel pump mounting bolts, the fuel pump lifter guide should be removed and inspected for wear.

To perform a fuel pump pressure check, you need to relieve the fuel system pressure.

Inspect it for contamination and clean if necessary.

For 2007 RX 350 and all 2008 and later models, the components of the fuel pump assembly are modular and attached to the main housing. To remove the fuel level sending unit, disconnect the electrical connector and pry it from the clips. To remove the fuel pump, disconnect the electrical connector from the mounting flange, remove the spring E-clip, release the claw connectors from the sub-tank, separate the fuel suction support base, release the claw connectors and separate the fuel pump assembly, disconnect and remove the fuel pump electrical harness, and pull the fuel pump up and out from the filter assembly. Remove the O-ring and spacer from the fuel pump, and inspect the strainer for contamination.