Toyota 77020-48140 Fuel Suction Tube Assembly W/Pump & Gage

You can Select Your Vehicle to check if 77020-48140 fits your vehicle.

Depress the release tab and pull up.

For 2007 RX 350 and all 2008 and later models, the components of the fuel pump assembly are modular and attached to the main housing. To remove the fuel level sending unit, disconnect the electrical connector and pry it from the clips. To remove the fuel pump, disconnect the electrical connector from the mounting flange, remove the spring E-clip, release the claw connectors from the sub-tank, separate the fuel suction support base, release the claw connectors and separate the fuel pump assembly, disconnect and remove the fuel pump electrical harness, and pull the fuel pump up and out from the filter assembly. Remove the O-ring and spacer from the fuel pump, and inspect the strainer for contamination.

During the fuel pump installation, the lifter should be installed by guiding it into the housing and aligning the key with the groove.

Remove the engine cover and unscrew the banjo bolt securing the crossover line to the front fuel rail. Screw the adapter into the rail and connect the fuel pressure test hose.