Toyota 81130-35470 Passenger Side Headlight Assembly

You can Select Your Vehicle to check if 81130-35470 fits your vehicle.

The photos below show the general headlight housing applicable to the 2005 models and below, while the case used in the 2006 above models is slightly different but resembles the one illustrated. Firstly, starting with the 2005 the models and before, the front bumper cover trim panel has to be removed, by using the screwdriver to get all the six retaining tabs out of their respective slots while gently releasing the claws from the locator pins. For the model of 2006 and the subsequent years, one must first unscrew the front bumper and then take off the upper seal that is part of the radiator support assembly. Next, pull the electrical connectors away from the headlight bulbs by squeezing on a release tab and pulling them from the sockets, and unscrew the parking / sidemarker light bulb socket, turning it counterclockwise. Next, unbolt the front bumper cover filler strip, if one has screws for model years before 2005 and a push pin for for model years after 2005. Then the three upper bolts on the headlight housing needs to be taken out and then the front wheel lug nuts need to be loosened along with the jacking up of the vehicle using jackstands and finally the front wheel along with the inner fender splash shield needs to be detached. Move to the removal of the lower headlight housing mounting bolt and then pulling the headlight housing. It is the process of uninstalling the assembly; after that, look into the headlight housing adjustment and make the necessary fixes.

No, the horizontal adjuster screw is locked in place by a retainer that prevents it from being adjusted. It should only be adjusted when installing a new replacement unit.