How to remove and install a hood on Toyota Highlander?

To remove or replace the hood, two people at least are required for this. You should open the hood first and then place blankets or pads over the fenders and cowl area to protect the body and paint. Disconnect all cables and wires that may affect removal especially windshield washer tubing near right side hinge. It is important to make marks around the hood hinge so as to assist in its proper alignment subsequently. Removing each end's clip of support along with separating supports from the hood is performed with assistance from a second person. Continue removing bolts of hinges-tohoods while supporting with shoulder till it is possible to lift it off. To reinstall, aligning hinge bolts with aforementioned marks is necessary. When adjusting, loosen bolts then move hood into correct alignment by using hinge plate slot. For adjustment of hood-to-hinge, replace factory bolts with standard ones. Marking around entire hinge plate allows one to establish degree of movement involved in it. After tightening these hinge bolts, lower then check where the position is on your assembly making tiny changes whenever necessary. The radiator support can be used for also adjusting vertically and horizontally on the latch assembly to ensure there is a secure flush closure for hood when it's closed Hood latch mounting bolts need either scribed line or mark placed around them before being loosened in order to reposition this assembly in other cases again Adjust the hood bumpers on radiator support until they fit snugly against fenders when closed lubricate often white lithium base grease which is used for preventing binding and wear on hoods latches assemblies.

Genuine Toyota Highlander Hood

Engine Hood

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

9 Hoods found

View related parts
Toyota Highlander Hood Sub-Assembly
Part Number: 53301-0E110
$383.19 MSRP: $564.07
You Save: $180.88 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Hood Sub-Assy; Hood
- Replaces: 53301-0E120
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2014-2019 Toyota Highlander | 4 Cyl 2.7L, 6 Cyl 3.5L | 1ARFE, 2GRFE, 2GRFKS, 2GRFXE, 2GRFXS; 1ARFE, 2GRFE, 2GRFKS, 2GRFXE, 2GRFXE; ASU50L-ARTNKA, 2GRFXS; ASU50L-ARTNKA, GSU50L-ARTGKA, GSU50L-ARTMKA, GSU50L-ARTNKA, GSU50L-ARZGHA, GSU50L-ARZMHA, GSU50L-ARZNHA, GSU55L-ARTGKA, GSU55L-ARTMKA, GSU55L-ARTNKA, GSU55L-ARZGHA, GSU55L-ARZMHA, GSU55L-ARZNHA, GVU58L-ARXGHA, GVU58L-ARXGKA, GVU58L-ARXMHA, GVU58L-ARXMKA, GVU58L-ARXNHA, GVU58L-ARXNKA
View related parts
Toyota Highlander Hood Sub-Assembly
Part Number: 53301-0E080
$381.99 MSRP: $562.29
You Save: $180.30 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Hood Sub-Assy; Hood
- Replaces: 53301-48160, 53301-48150
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2010-2013 Toyota Highlander | Limited, Medium, STD, Sport | 4 Cyl 2.7L, 6 Cyl 3.5L | 1ARFE, 2GRFE, 2GRFXE; 1ARFE, 2GRFE; ASU40L-ARTNKA, 2GRFXE; GVU48L-BRXGKA, GSU40L-ARAGKA, GSU40L-ARAMKA, GSU40L-ARANKA, GSU40L-ARASKA, GSU45L-ARAGKA, GSU45L-ARAMKA, GSU45L-ARANKA, GSU45L-ARASKA, GVU48L-BRXNKA
View related parts
Toyota Highlander Hood Sub-Assembly
Part Number: 53301-0E050
$433.83 MSRP: $638.59
You Save: $204.76 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Hood Sub-Assy; Hood
- Replaces: 53301-48120
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2008-2011 Toyota Highlander | Grande, Limited, Medium, STD, Sport | 4 Cyl 2.7L, 6 Cyl 3.3L, 6 Cyl 3.5L | 1ARFE, 2GRFE, 3MZFE; 1ARFE, 2GRFE, 2GRFE; ASU40L-ARTNKA, 3MZFE; ASU40L-BRTNKA, GSU40L-ARAGKA, GSU40L-ARAMKA, GSU40L-ARANKA, GSU40L-ARASKA, GSU40L-BRAGKA, GSU40L-BRAMKA, GSU40L-BRANKA, GSU40L-BRASKA, GSU45L-ARAGKA, GSU45L-ARAMKA, GSU45L-ARANKA, GSU45L-ARASKA, GSU45L-BRAGKA, GSU45L-BRAMKA, GSU45L-BRANKA, GSU45L-BRASKA, MHU48L-BRXMKA, MHU48L-BRXNKA
View related parts
Toyota Highlander Hood Sub-Assembly
Part Number: 53301-0E170
$459.12 MSRP: $675.82
You Save: $216.70 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Hood Sub-Assy; Hood
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2020-2022 Toyota Highlander | 4 Cyl 2.5L, 6 Cyl 3.5L | 2GRFKS, A25AFXS; 2GRFKS, A25AFXS; AXUH70L-ARXGHA, AXUH70L-ARXMHA, AXUH70L-ARXNHA, AXUH78L-ARXGHA, AXUH78L-ARXMHA, AXUH78L-ARXNHA, GSU70L-ARZGHA, GSU70L-ARZMHA, GSU70L-ARZNHA, GSU70L-ARZSHA, GSU75L-ARZGHA, GSU75L-ARZMHA, GSU75L-ARZNHA, GSU75L-ARZSHA
View related parts
Toyota Highlander Hood Sub-Assembly
Part Number: 53301-48120
$433.83 MSRP: $638.59
You Save: $204.76 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Hood Sub-Assy
- Replaced by: 53301-0E050
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2008-2011 Toyota Highlander | Grande, Limited, Sport, STD | 4 Cyl 2.7L, 6 Cyl 3.3L, 6 Cyl 3.5L | 1ARFE, 2GRFE, 3MZFE; 1ARFE, 2GRFE, 3MZFE; ASU40L-BRTNKA, GSU40L-BRAGKA, GSU40L-BRAMKA, GSU40L-BRANKA, GSU40L-BRASKA, GSU45L-BRAGKA, GSU45L-BRAMKA, GSU45L-BRANKA, GSU45L-BRASKA, MHU48L-BRXMKA, MHU48L-BRXNKA
View related parts
Toyota Highlander Hood Sub-Assembly
Part Number: 53301-48090
$444.66 MSRP: $654.54
You Save: $209.88 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Hood Sub-Assy; Hood
- Replaces: 53301-48040
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2001-2007 Toyota Highlander | 4 Cyl 2.4L, 6 Cyl 3.0L, 6 Cyl 3.3L | 1MZFE, 2AZFE, 3MZFE; 1MZFE, 2AZFE, 3MZFE; ACU20L-BRPNKA, ACU20L-BWPNKA, ACU25L-BRPNKA, ACU25L-BWPNKA, MCU20L-BWPNKA, MCU23L-BRANKA, MCU23L-BWANKA, MCU25L-BWPNKA, MCU28L-BRANKA, MCU28L-BWANKA, MHU23L-BRXNKA, MHU23L-BWXNKA, MHU28L-BRXNKA, MHU28L-BWXNKA
View related parts
Toyota Highlander Hood Sub-Assembly
Part Number: 53301-48160
$381.99 MSRP: $562.29
You Save: $180.30 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Hood Sub-Assy
- Manufacturer Note: CANADA SPEC
- Replaced by: 53301-0E080
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2010-2013 Toyota Highlander | Limited, STD | 6 Cyl 3.5L | 2GRFXE; 2GRFXE; GVU48L-BRXGKA, GVU48L-BRXNKA
View related parts
Toyota Highlander Hood Sub-Assembly
Part Number: 53301-48040
$444.66 MSRP: $654.54
You Save: $209.88 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Hood Sub-Assy
- Replaced by: 53301-48090
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2001-2004 Toyota Highlander | 4 Cyl 2.4L, 6 Cyl 3.0L, 6 Cyl 3.3L | 1MZFE, 2AZFE, 3MZFE; 1MZFE, 2AZFE, 3MZFE; ACU20L-BRPNKA, ACU20L-BWPNKA, ACU25L-BRPNKA, ACU25L-BWPNKA, MCU20L-BWPNKA, MCU23L-BRANKA, MCU23L-BWANKA, MCU25L-BWPNKA, MCU28L-BRANKA, MCU28L-BWANKA
View related parts
Toyota Highlander Hood Sub-Assembly
Part Number: 53301-0E120
$383.19 MSRP: $564.07
You Save: $180.88 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Hood Sub-Assy
- Replaced by: 53301-0E110
- Warranty: This genuine part is guaranteed by Toyota's factory warranty.
Fits the following Vehicles:
- 2014-2015 Toyota Highlander | 4 Cyl 2.7L, 6 Cyl 3.5L | 1ARFE, 2GRFE, 2GRFXE; 1ARFE, 2GRFE, 2GRFXE; ASU50L-ARTNKA, GSU50L-ARTGKA, GSU50L-ARTMKA, GSU50L-ARTNKA, GSU55L-ARTGKA, GSU55L-ARTMKA, GSU55L-ARTNKA, GVU58L-ARXGKA, GVU58L-ARXMKA, GVU58L-ARXNKA

Toyota Highlander Hood

If you are in demand for superior quality and affordable OEM Toyota Highlander Hood, then shop with us! We own a wide range of the reduced-priced genuine Toyota Highlander Hood. You can purchase in confidence as all parts come with a manufacturer's warranty. Any issues with our products? No need to worry as we have a hassle-free return policy to guide you every step of the way.

Toyota Highlander Hood Parts Questions & Experts Answers

Hood Sub-Assembly
53301-0E110
Q: How to remove and install a hood on Toyota Highlander?
A: To remove or replace the hood, two people at least are required for this. You should open the hood first and then place blankets or pads over the fenders and cowl area to protect the body and paint. Disconnect all cables and wires that may affect removal especially windshield washer tubing near right side hinge. It is important to make marks around the hood hinge so as to assist in its proper alignment subsequently. Removing each end's clip of support along with separating supports from the hood is performed with assistance from a second person. Continue removing bolts of hinges-tohoods while supporting with shoulder till it is possible to lift it off. To reinstall, aligning hinge bolts with aforementioned marks is necessary. When adjusting, loosen bolts then move hood into correct alignment by using hinge plate slot. For adjustment of hood-to-hinge, replace factory bolts with standard ones. Marking around entire hinge plate allows one to establish degree of movement involved in it. After tightening these hinge bolts, lower then check where the position is on your assembly making tiny changes whenever necessary. The radiator support can be used for also adjusting vertically and horizontally on the latch assembly to ensure there is a secure flush closure for hood when it's closed Hood latch mounting bolts need either scribed line or mark placed around them before being loosened in order to reposition this assembly in other cases again Adjust the hood bumpers on radiator support until they fit snugly against fenders when closed lubricate often white lithium base grease which is used for preventing binding and wear on hoods latches assemblies.