Scion 90981-13044 Bulb

You can Select Your Vehicle to check if 90981-13044 fits your vehicle.

Depending on the make and model, some of these vehicles come with Halogen or LED type of headlamps For the information on how to replace the bulb applies to the Halogen type only. For a bulb on the right side or the rear, the plastic retainer has to be first removed and the windshield washer fluid reservoir neck moved out of the way. First, they placed a call for performance that included not only a degree of output above the base model but also a design enhancer for a low-beam bulb replacement where all one has to do is unscrew the weather sealing cap at the base which is counterclockwise. Subsequently, depower and remove the electrical connector therein which the tab is lifted prior to disconnecting. Make sure to get a good grip on the bulb holder providing that twist it in a leftwards direction to release it from the housing. Carefully twist a new bulb assembly installed into the headlight housing without coming into contact with the glass with bare hands and turn it to bring its tabs with the cutouts. Last but not the least, reconnect the electrical plug and if a low-beam bulb has been replaced, replace the weather sealing cap.

Unplug the electrical connector from the headlight bulb holder. On T100 models, rotate the plastic bulb holder cover counterclockwise and remove it.

Depress the release tab and pull off the connector.

Depress the release tab and disconnect the electrical connector from the high-beam headlight bulb socket.

To remove the bulb socket from the headlight housing, you need to turn it counterclockwise and pull it out of the housing.

To remove the bulb socket from the headlight housing, you need to turn it counterclockwise and pull it out of the housing.

Pry off the outer cover of the side view mirror housing, remove the turn signal mounting fasteners, and rotate the bulb counterclockwise to remove it.

Pull straight out on the bulb to remove it from the bulb holder.

Remember that if the light has just been in use, the bulb may be extremely hot.

For Lexus models, reinstall the round cover over the low-beam bulb and then reinstall the headlight housing.

You can access these bulbs by removing access panels in the trunk interior.

Reach behind the headlight assembly and rotate the bulb holder counterclockwise to remove the bulb.

Fit the new bulb, twisting it clockwise into the back of the light unit to secure it, then reconnect the wiring plug and refit the wheel arch liner screws.

Raise the front of the vehicle and place it securely on jackstands.

Grasp the bulb holder securely and rotate it counterclockwise to remove it from the housing. This step also applies to the fog lamp bulb holder.

Release the spring clip to remove the bulb holder.

Unplug the electrical connector, then twist the bulb holder to remove it from the light housing.

They are all part of the headlight housing and are accessible from behind the headlight housing, although it may be difficult.

Remove the retaining screws and detach the lens. Remove the bulb from the holder by pulling it straight out of the housing.

Installation is the reverse of removal.

Reach behind the headlight assembly and unplug the electrical connector.

The bulb is a push-fit in its holder; pull the old one out and press in a new one.

Twist the bulb anti-clockwise to remove it from the back of the light unit.