Toyota 48510-49505 Shock Absorber Assembly Front Right

You can Select Your Vehicle to check if 48510-49505 fits your vehicle.

If the lower insulator is being replaced, set it into position with the dropped portion seated in the lowest part of the seat. Then, extend the damper rod to its full length and install the rubber bumper.

1. Maneuver the assembly up into the fenderwell, install the lower mount onto the stud, and guide the upper mounting studs into the holes in the body. Install the bolt from below, tightening it. 2. Install the lower washer and nut. Raise the axle beam with the floor jack to simulate normal ride height, then tighten the nut. 3. Install the upper mounting nuts and tighten them. 4. The remainder of installation is the reverse of removal. 5. Install the wheel and lug nuts. Lower the vehicle and tighten the lug nuts.

Check the strut body for leaking fluid, dents, cracks, and other obvious damage that would warrant repair or replacement.