Toyota 48710-48030 Rear Suspension Control Arm Assembly, No.1 Left

You can Select Your Vehicle to check if 48710-48030 fits your vehicle.

Installation is the reverse of the removal procedure. Be sure to tighten the bolts to the specified torque.

1. Lower the rear suspension cross member to access the bolt on the inner end of the number 1 suspension arm. 2. Disconnect the strut rods from the axle carrier on both sides of the vehicle. 3. Remove the exhaust center section and tailpipe. 4. Remove the driveshaft and center bearing assembly. 5. Remove both rear driveaxles. 6. Detach the suspension arms from both axle carriers. 7. Position a floor jack under the center of the cross member, loosen and remove the cross-member-to-body fasteners, and carefully lower the rear suspension cross member until the suspension arm bolts are accessible. Remove the bolts.