Toyota 48710-48070 Rear Suspension Control Arm Assembly, No.1 Left

You can Select Your Vehicle to check if 48710-48070 fits your vehicle.

It therefore requires that any rear suspension arms that were removed or replaced be refitted, loosely tightened, positioned to its normal ride-height angle and then again tightened until fully tight. First of all shift the wheel lug nuts to the loose position then jack up the car and securely place it on jack stands then remove the wheel. After this, unscrew the strut rod-to-axle carrier bolt and then also contract the strut rod-to-body bracket to remove the rod from the vehicle. In the process of removing the strut bolt it may be required that the parking brake cable bracket be detached. During installation reverse the sequence of removal and always tighten the bolts to the prescribed torque.

1. Lower the rear suspension cross member to access the bolt on the inner end of the number 1 suspension arm. 2. Disconnect the strut rods from the axle carrier on both sides of the vehicle. 3. Remove the exhaust center section and tailpipe. 4. Remove the driveshaft and center bearing assembly. 5. Remove both rear driveaxles. 6. Detach the suspension arms from both axle carriers. 7. Position a floor jack under the center of the cross member, loosen and remove the cross-member-to-body fasteners, and carefully lower the rear suspension cross member until the suspension arm bolts are accessible. Remove the bolts.