Toyota 48710-0E060 Rear Suspension Control Arm Assembly, No.1 Right

You can Select Your Vehicle to check if 48710-0E060 fits your vehicle.

Loosely tighten all the bolts, move the suspension to its normal ride-height angle and position, then fully tighten the bolts.

1. Lower the rear suspension cross member to access the bolt on the inner end of the number 1 suspension arm. 2. Disconnect the strut rods from the axle carrier on both sides of the vehicle. 3. Remove the exhaust center section and tailpipe. 4. Remove the driveshaft and center bearing assembly. 5. Remove both rear driveaxles. 6. Detach the suspension arms from both axle carriers. 7. Position a floor jack under the center of the cross member, loosen and remove the cross-member-to-body fasteners, and carefully lower the rear suspension cross member until the suspension arm bolts are accessible. Remove the bolts.