Toyota 90981-13090 Bulb

You can Select Your Vehicle to check if 90981-13090 fits your vehicle.

To replace the front park/turn signal lights and side marker lights, open the hood, locate the bulb holder, turn it counterclockwise, and pull it from the housing to remove the old bulb and install a new one. For rear tail light, brake light, and turn signal bulbs, remove the two screws securing the fender assembly, pull the housing straight back to release the pins, then rotate the bulb holders counterclockwise to remove the bulbs and install new ones. For liftgate bulb replacement, use a flat trim tool to remove the access cover, turn the bulb holder counterclockwise, and pull the bulb straight out to install a new one. The high-mounted brake light requires removing the liftgate trim panel, unscrewing the mounting screws, and pulling the light assembly out. Interior lights can be accessed by prying off the lens, replacing the bulbs, and reinstalling the lens. For license plate lights, pry out the access panel, turn the bulb holder counterclockwise, and replace the bulb. To replace fog lights, park the vehicle with the wheel pointing inward, remove fasteners from the inner fender splash shield, peel it back for access, unplug the connector, and twist the bulb holder to remove it. For outside mirror turn signal lights, carefully pry off the outer cover, disconnect any heating elements or blind spot monitor connectors if equipped, remove the mounting fasteners, detach the clips, and rotate the bulb counterclockwise to remove it. Installation for all components is the reverse of removal.

Installation is the reverse of removal.

The inner headlight bulbs are the high-beam bulbs, while the outer bulbs are the low-beam bulbs. The low-beam bulbs are also illuminated when the high-beam bulbs are turned on.

Open the hood. If you're replacing the right-side headlight, remove the windshield washer reservoir for access to the bulb. If you're removing the left-side headlight, remove the cover from the fuse/relay box for access to the bulb. If that doesn't give you enough working room, you can unbolt the fuse/relay box for more access. Otherwise, the headlight housing will have to be removed. Reach behind the headlight assembly and unplug the electrical connector by depressing the clip on the harness connector.

Remove the weather sealing cap by turning it counterclockwise to detach it from the headlight housing.

Carefully pry out the interior light housing from the trim panel.

The first step is to unplug the electrical connector from the headlight bulb holder (unplug the electrical connector from the headlight bulb; low beam and high beam).

They use LED fog lights, which are not serviceable. If there is a problem with an LED fog light, the entire fog light assembly must be replaced.