Toyota 77035-AE010 Cable Sub-Assy, Fuel Lid Lock Control

You can Select Your Vehicle to check if 77035-AE010 fits your vehicle.

Disconnect the negative battery cable and remove the rear fenderwell liner. Twist the Fuel Door Release Cable end on a quarter-turn counterclockwise and pull it from the fuel door housing. Pry up the driver's side doorsill covers and remove the center door pillar's lower trim panel. Peel back the carpeting to access the release cable and open all of the clips holding the cable to the body. Remove the two screws holding the release handle assembly to the floor and the screw holding the fuel door release assembly to the floor. Turn the housing over and remove the cable housings from the clips and detach the cable eye from the slot in the lever. Attach a piece of thin wire to the end of the cable, then, working in the rear fenderwell, pull the cable towards the rear of the vehicle until the wire is visible. Attach the wire to the front of the new cable and fish it back through the body until it can be attached to the lever, completing the installation in reverse order of removal.