Toyota 47730-08030 Cylinder Assy, Front Disc Brake, RH

You can Select Your Vehicle to check if 47730-08030 fits your vehicle.

Always replace the calipers in pairs; never replace just one. To remove, first loosen the wheel lug nuts, raise the vehicle, and support it securely on jackstands before removing the wheels. Next, disconnect the brake hose by removing the banjo bolt and plugging the hose to prevent contaminants from entering the brake system and to minimize brake fluid loss. If only accessing other components, do not detach the hose. Then, remove the caliper mounting bolts and take out the caliper. If needed, also remove the caliper torque plate from the steering knuckle or rear axle carrier by taking out the appropriate bolts. For installation, reverse the removal steps, ensuring to install new sealing washers on either side of the brake hose banjo fitting and tighten the caliper mounting bolts and torque plate bolts to the specified torque. Finally, bleed the brake system, install the wheels and lug nuts, lower the vehicle, and tighten the lug nuts to the specified torque.

Remove the caliper mounting bolts.

Finally, install the wheels and lug nuts onto the vehicle. Lower the vehicle from the jackstands and ensure it is properly supported. Tighten the lug nuts to the appropriate torque specifications.

Remove the caliper. If you're removing a rear caliper, unscrew the caliper from the brake hose. If necessary, remove the caliper torque plate from the steering knuckle.