Toyota 43502-14040 Front Axle Hub Sub-Assembly

You can Select Your Vehicle to check if 43502-14040 fits your vehicle.

Despite being non-serviceable, the same sealed bearing is held by snap ring in the same location as before installed in the steering knuckle on 1987 through 1992 models. When it comes to front bearing problems, it is always best to let a dealer service department or at least a reputable shop to put in new bearings. Removing front hub is necessary for examining front wheel bearings that is a standard procedure. When there is an assumed case of a wheel bearing, the analyst has to use a dial indicator to measure the in and out play on the spindle of the hub. If these factors are overplayed then it is the technician's hint that it is time for the wheel bearings to be serviced as well as the bearing preload to be adjusted. During the disassembly of the hub, if there is any wear of the bearings and races, then this can easily be seen and replaced if required.

Pack the bearings with high-temperature front wheel bearing grease and apply a thin coat of grease to the spindle. Place a small amount of grease behind each bearing race inside the hub.