Toyota 12380-0A031 Insulator Assy, Engine Mounting, Rear

You can Select Your Vehicle to check if 12380-0A031 fits your vehicle.

To remove the engine movement control rod assembly in V6 models, you need to take out the two through-bolts and the engine movement control rod.

For transaxle mount replacement, you can follow a similar procedure to engine mount replacement. The key steps involve supporting the transaxle and removing and installing the transaxle mount using appropriate fasteners and thread locking compound. Ensure that the transaxle mount is securely attached to prevent driveline issues.

Engine mounts seldom require attention, but broken or deteriorated mounts should be replaced immediately to prevent damage or wear on driveline components.

Raise the vehicle and support it securely on jackstands. Then, position a jack under the engine oil pan with a large wood block between the jack head and the oil pan. Carefully raise the engine just enough to take the weight off the mounts, ensuring the wood block is not positioned under the drain plug.

To check the engine mounts, you should raise the vehicle and securely support it on jackstands. Position a jack under the engine oil pan and place a large block of wood between the jack head and the oil pan. Raise the engine slightly to remove the weight from the mounts. Do not position the wood block under the drain plug. Then, visually inspect the mounts for signs of damage and use a large screwdriver or pry bar to check for any movement. If movement is observed, lower the engine and tighten the mount fasteners. Applying rubber preservative to the mounts can help slow down deterioration.

V6 models have a shock absorbing mount, which is mounted between the engine and chassis. It is located to the left of the conventional front engine mount.