Toyota 90311-42032 Seal

You can Select Your Vehicle to check if 90311-42032 fits your vehicle.

Using a socket with an outside diameter slightly smaller than the outside diameter of the seal, carefully drive the new seal into place with a hammer. Gently tap the new seal into place with the spring side toward the engine, ensuring it's installed squarely and driven in to the same depth as the original. If a socket isn't available, a short section of large diameter pipe can also be used. After installation, check the seal to make sure the garter spring didn't pop out of place.

The seal lips must be lubricated with clean engine oil or moly-based grease before the seal/retainer is slipped over the crankshaft and bolted to the block. A new gasket and sealant should be used, and it is important to ensure that the dowel pins are in place before installing the retainer.

Lubricate the crankshaft seal journal and the lip of the new seal with moly-base grease. Position a new gasket on the engine block.