Toyota 90311-25021 Seal

You can Select Your Vehicle to check if 90311-25021 fits your vehicle.

Remove the crankshaft pulley. Screw a self-tapping screw into the face of the old Crankshaft Seal and using a pair of long-nosed-pliers and a piece of a timber to lever against, lever the old seal from the timing cover. Fitting a self-tapping screw helps to pull the old seal out. Lightly lubricate the seal with oil or grease, and position it over the crankshaft. Work equally round the seal, tapping it squarely into the carrier until it is flush with the edge. Install the crankshaft pulley. Remove the flywheel or driveplate. Using the same method, remove the rear main seal. Lightly lubricate the seal with oil or grease, and position it over the crankshaft. Work equally round the seal, tapping it squarely into the carrier until it is flush with the edge. If a tube of the same diameter as the seal is available, this will help to ensure the seal is pressed squarely into place. Otherwise, the seal should be pressed in evenly using a blunt instrument. Work equally round the seal, tapping it squarely into place until it is fitted to the same depth as the old one. Refit the flywheel or driveplate.

Remove the flywheel (refer to Section 16).

Check the surface on the pulley hub that the oil seal rides on. If the surface has been grooved from long-time contact with the seal, replace the pulley.

Work equally around the seal, tapping it squarely into the carrier until it is flush with the edge.